The Tennessee Classic is an annual pilgrimage for many bowyers, knappers, and traditional archers throughout the southeastern and midwestern United States (and even some beyond). Every year hundreds of archers gather with their families in a valley near Clarksville, Tennessee and camp out, craft gear, and lose arrows in thick vegetation beyond tricky 3D targets. The actual 3D shoot, organized by the Twin Oaks Bowhunters, takes place on a Saturday and Sunday in April of May. Many arrive up to a week in advance, however, just to enjoy good company amidst amazing scenery.
This year marked the 20th annual gathering and was incredible as always, with record attendance despite heavy rains that soaked the course for two days straight before the shoot.
Thanks to the Twin Oaks Bowhunters for all their hard work setting up such a great event!
A few weeks ago I wrote a post about a shortbow I built and named Jumper. I hailed the all-forgiving Osage for allowing me to coax a bow from firewood. Today that stave’s forgiveness ran out and I learned a lesson about over-stressing wood.
Red marks indicate failure points on the back of the bow due to tension (left) and on the belly due to compression (right). The chrysals, or compression fractures, are directly opposite the limb from the splinter. Contrast is enhanced to the point of ugliness to show the chrysals.
I strung Jumper up cold and fired off a few arrows. There were no audible cracks, no strange feelings, and no other telltale sign of wood failure. It shot like it had hundreds of times before.
I recently bent reflex into an Osage stave and learned a few lessons. These may be obvious to the seasoned bowyer, but I want to share my growing pains in case the reader is interested in trying to bend wood with dry heat themselves. The lessons are stated in bullet points at the end of the post for those not interested in my rambling.
The Osage stave in question was roughed from a small diameter tree and has a slightly crowned back. It’s 52″ tip-to-tip and tapers to 1/2″ over the last 8″ of each limb. I most likely wouldn’t have reflexed it had it not demanded it. But after roughing it out I was left with one limb reflexed about 2″ and the other dead straight. I hadn’t had much luck reflexing bows before, but it was time to face the music: this bow would be reflexed, or it wouldn’t be a bow. After reviewing the Bending Wood chapter in The Traditional Bowyer’s Bible, Vol. 2, I cut a form out of a 2×8, fired up the heat gun (pun slightly intended, sorry), and set to work.
Tipping an arrow with a spent .38 cartridge is an old trick. It’s a cheap way to blunt your arrows for hunting small game. Some even put nails through the cartridge after it’s glued to the arrow to keep the arrow from burrowing when stump shooting.
Tools needed for tipping an arrow with a .38 cartridge: arrow shaft, lighter, hot glue, the cartridge, some pliers, and a cold one in your favorite koozie.
Not long ago I broke a judo off my stumping arrow and was lucky enough to capture it in slow-motion:
See a more recent update on this bow here.
It’s happened to any bowyer that splits their own staves. You start with a halved or quartered log and analyze the grain. You find a straight area that looks long enough to hold a bow. You position your splitting wedge or hatchet at the exact spot that you think will yield the cleanest stave. You swing back your hammer and plink! The log splits across the grain, running off the edge halfway down the log, while dirty words frolic around your mind.
But that doesn’t always spell disaster.