housing_montage

A wire was soldered to each of the two pins on the back of each bulb, then threaded through a 90 degree PVC elbow. Silicone was applied to the opening of the elbow, and the lights were seated in it and allowed to dry. The elbows were connected to an upright length of PVC as shown, and the wire threaded through the top. Silicone was applied to the joints at the end to ensure sealing.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s